Replacement Refrigerator Water Filter For:
PUR T2WG2
Filter Features
-
Filter Life: 6-Months
-
Filter Capacity: 200 Gallon
-
NSF Certified 42 & 53
-
Taste
-
Odor
-
Chlorine
-
Reduces 24 Contaminants Including Pharmaceuticals
-
Replacement Refrigerator Water Filter For:
T2WG2
2-Pack ($35.99)
Save:
$34.00
158 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
T2WG2
3-Pack ($52.99)
Save:
$47.00
237 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
T2WG2
4-Pack ($69.99)
Save:
$60.00
95 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
T2WG2
6-Pack ($102.99)
Save:
$27.00
69 Review
Add To Cart
Remove unhealthy contaminants and any haziness efficiently from your drinking water with PUR T2WG2 at Clatterans which uses the highest quality activated carbon and certifies to IAPMO, NSF/ANSI water treatment standards 42 for trapping and reducing detrimental impurities to reach the best water filtration results. We have numerous PUR refrigerator filter replacements to fit perfectly in your fridge. Fitermodel is an acceptable substitute without compromise on quality and flow to provide wholesome sweet water for your whole family. Drink safe water and taste clean ice from Clatterans filters.
Fits The Following Series
45429 Series |
45433 Series |
58703 Series |
51103 Series |
51102 Series |
1.Press the eject button to release the filter from the base grille.
2.Pull the filter straight out.
3.Turn the cap counterclockwise to remove it from the filter.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
4.Align the ridge on the cap with the arrow on the new filter and turn the cap until it snaps into place.
NOTE: You can run the dispenser without a filter. Your water will not be filtered. Simply insert the cap all of the way into the base grille and rotate the cap until it is firmly in place.
5.Remove the protective covers from the O-rings. Be sure the O-rings are still in place after the covers are removed.
6.Push the filter into the base grille. The eject button will pop back out when the filter is fully engaged.
7.Run water from the dispenser for 5 minutes at .5 gpm (about 2½ gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours
8.Reset the “replace filter” light, if needed, by holding the reset button for three seconds.
Top customer reviews
-
By Ronald Kubik On 2019-02-16 03:00:28
I ordered the 3-pack of these last year and am now using the second filter, they work fine just like the much more expensive pur filters. In fact, my experience is that the water tastes BETTER using these, but that is just my own subjective judgment. Today I re-ordered and this time got the 6 pack, and will be all set for 3 years at least. It's been so hard to find these at a reasonable price over the years, now that I found good inexpensive ones I've stocked up. I thought maybe because these are cheap they wouldn't last as long, but the one I just replaced was in for more than 6 months and water still tastes fine. This was not the case with pur filters I've purchased in recent years, those seemed to wear out after only a few months.
-
By Traci On 2018-12-29 04:39:11
An exact replacement for my original filter. Easy to install and the water tastes GREAT! -- even better than the original filter. I could not be happier!
-
By Clark On 2018-12-28 01:36:53
Works perfectly. This is the third filter over last 2 years and as always it is perfect quality, fits like new, and I will be ordering replacements in the future.
-
By Edith On 2018-12-28 00:11:51
Replaced former filter perfectly. Good filter and the water tastes much better with this filter. Timely delivery and just as expected.
-
By Kate On 2018-12-25 04:52:10
This is the BEST water filter and best Christmas gift I get. House water taste better than purchased bottled water. Wish they weren't so pricey, but the water quality is amazing!
-
By Molly On 2018-12-23 01:52:08
I have tried the off brand, cheaper replacement filter and it didn't work very well. I recommend buying this filter if you want to filter your water in your whirlpool refrigerator.
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
Live Customer Support
Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.