Replacement Refrigerator Water Filter For:
Whirlpool 46 9903
Filter Features
-
NSF Certified 42 & 531
-
Filter Life: 6 Months
-
Filter Capacity: 200 Gallons
-
Replacement Refrigerator Water Filter For:
46 9903
6-Pack ($99.99)
Save:
$30.00
70 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
46 9903
4-Pack ($67.99)
Save:
$52.00
74 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
46 9903
3-Pack ($52.99)
Save:
$47.00
185 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
46 9903
2-Pack ($35.99)
Save:
$34.00
131 Review
Add To Cart
Change your Whirlpool filter with Clatterans water filter replacement every six months or longer to get the clearer and cleaner water from your Whirlpool refrigerator. Approved by IAPMO and NSF/ANSI 42, Whirlpool 46 9903 will leave you the peaceful mind that the filtered water from 46 9903 Whirlpool refrigerator is reliable to drink for the household. The superb carbon delivers drinking water and ice without nasty impurities and harmful elements like dirt and lead, mercury which will pose health issues if we drink for a long time. Change the filter is much easier as everything is prepared well.
Fits The Following Series
ED2GHEX Series
ED5RHEX Series
GC5SHGX Series
GS2SHAX Series
GS2SHEX Series
Whirlpool Refrigerator Models
-
WRF989SDAB02
-
WRF989SDAB01
-
WRF989SDAB00
-
WRF989SDAB
-
WRF560SMYW00X
-
WRF560SMYM00
-
WRF560SMYH02
-
WRF560SMYH01
-
WRF560SMYH00
-
WRF560SMYE02
-
WRF560SMYE01
-
WRF560SMYE00
-
WRF560SMYB00
-
WRF560SFYW00
-
WRF560SFYM00
-
WRF560SFYE00
-
WRF560SFYB00
-
WRF560SEYW00
-
WRF560SEYM00
-
WRF560SEYB00
-
WRF989SDAB03
-
WRF989SDAE
-
WRF989SDAE00
-
WRF989SDAF
-
WRF989SDAF00
-
WRF989SDAH
-
WRF989SDAH00
-
WRF989SDAM
-
WRF989SDAM00
-
WRF989SDAW
-
WRF989SDAW00
-
WRF989SDAW00
-
WRF989SDAW
-
WRF989SDAM00
-
WRF989SDAM
-
WRF989SDAH00
-
WRF989SDAF00
-
WRF989SDAF
-
WRF989SDAE00
-
WRF989SDAE
-
WRF989SDAB03
-
WRF989SDAB02
-
WRF989SDAB01
-
WRF989SDAB00
-
WRF989SDAB
-
WRF560SMYW00X
-
WRF560SMYM00
-
WRF560SMYH01
-
WRF560SMYE02
-
WRF560SMYE01
-
WRF560SMYE00
-
WRF560SMYB00
-
WRF560SFYW00
-
WRF560SFYM00
-
WRF560SFYE00
-
WRF560SFYB00
-
WRF560SEYW00
-
WRF560SEYM00
-
WRF560SEYB00
-
WRF989SDAH
-
WRF560SMYH00
-
WRF560SMYH02
1.Locate the accessory packet in the refrigerator and remove the water filter.
2.Take the water filter out of its packaging and remove the cover from the O-rings. Be sure the O-rings are still in place after the cover is removed.
NOTE: There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills.
3.Align the arrow on the water filter label with the cutout notch in the filter housing and insert the filter into the housing.
4.Turn the filter clockwise until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate. Water will not flow from the dispenser.
5.While the compartment door is still open, lift the filter up into the compartment. Then, close the filter compartment door completely.
6.Run water from the dispenser for 5 minutes at .5 gpm (about 2½ gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours
7.Reset the “replace filter” light, if needed, by holding the reset button for three seconds.
Top customer reviews
-
By Rhonda On 2023-08-13 00:00:00
The installation process was effortless
-
By Alfred Holley On 2023-08-08 00:00:00
I received exactly what I ordered, and the water tasted amazing with this filter.
-
By kimberly On 2023-07-24 00:00:00
I'm giving it 4 stars because of the shipping delay, but overall, it's an easy-to-install filter that does its job effectively.
-
By Shelly Lemiesz On 2023-07-19 00:00:00
It is exactly what I needed, and it has exceeded my expectations.
-
By Cheryl Neal On 2023-06-26 00:00:00
This refrigerator filter is a must-have for clean and pure drinking water.
-
By Ralph Swanson On 2023-06-11 00:00:00
This filter greatly improves the quality of our water.
Common Water Filter Questions
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!