Replacement Refrigerator Water Filter For:
Whirlpool EDR4RXD1B
Filter Features
-
Filter Life: 6 Months
-
Filter Capacity: 400 Gallons
-
Filter Type: Generic
-
Taste
-
Odors
-
Chlorine
-
Replacement Refrigerator Water Filter For:
EDR4RXD1B
3-Pack ($49.99)
Save:
$40.00
126 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
EDR4RXD1B
2-Pack ($34.99)
Save:
$35.00
110 Review
Add To Cart
Savor fresh and sweet beverages or cups of coffee filtered by EDR4RXD1B in your Whirlpool refrigerator. Certified by IAPMO and NSF/ANSI standard 42, activated by first-class carbon, Clatterans EDR4RXD1B will capture the particulates, dirt, sand, rust and other sediments for performing clearer, cleaner drinking water and ice cubes to your family and friends. With a durable and long-lasting six-month lifespan, feel assured to get quick flow rate and healthy drinking water in the following days. Invite your fellows to your house now to open a fabulous gather now to enjoy the blinking drinks and dishes owing to the flowing water from your Whirlpool fridge.
Fits The Following Series
72012 Series
72019 Series
78572 Series
78573 Series
78574 Series
1. Locate the filter cartridge holder in the back upper right hand corner of the refrigerator. To open the cartridge cover, where indicated, push in and the cover will drop down
2. Remove the old filter by slowly rotating it to the left. A small amount of water may drip down
3. Remove the red protective plug from the end of the new cartridg
4. Position the cartridge inside the cartridge holder. Slowly rotate the cartridge to the right until it stops.When the cartridge is properly installed, you will feel it “click” as it locks into place. The blade on the end of the cartridge should be positioned vertically. Do not overtighten
5. Close the cartridge cover.
6. Run water from the dispenser for 5 minutes (approximately 3 gallons) to clear the system and prevent air from entering the system
7. Locate the included Water Filter Replacement Calendar. Place the dark circle over the month that you installed your new filter. The light circle will indicate your tentative next replacement month. (This cycle can vary with water conditions and frequency of use).
Top customer reviews
-
By Elvira On 2018-10-29 09:40:06
Bought this for our Maytag fridge. Water taste great. Couldn't tell you how long it last, as we change it every 6 months.
-
By Sonia On 2018-10-23 08:08:52
Great product. The filter sputtered a bit when first installed but after I ran quite a bit of water through the filter it quieted down and now works like a charm.
-
By Vanessa On 2018-10-19 06:06:39
I tried the knock off brands and the taste of the water and ice cubes was just off. Clatterans water filters are a little bit expensive but you are getting what you pay for.
-
By Alfred On 2018-10-15 10:15:55
This is the 3rd time I have purchased this product and I'm very happy with the results of cleaner water. We have well water and a full house water filter on our home, but this product is extra filter for our drinking water.
-
By Sabrina On 2018-10-10 23:54:05
Purchased this to replace our Whirlpool refrigerator filter. The water flow rate appears to be the same and I would buy this filter again. Finding the OEM filters is difficult and they are more expensive, so this is our new go-to fridge filter.
-
By Audrey On 2018-10-05 23:16:42
Water tasted better than the cheaper filters. Used those cheaper ones with no luck, terrible tasting water and ice. Price is on the high side, but offsets the cost of buying bottled water. Let's see how long this will last.
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
Live Customer Support
Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.