Replacement Refrigerator Water Filter For:
Kenmore EDR4RXD3
Filter Features
-
Filter Life: 6 Months
-
Filter Capacity: 400 Gallons
-
Filter Type: Generic
-
Taste
-
Odors
-
Chlorine
-
Replacement Refrigerator Water Filter For:
EDR4RXD3
3-Pack ($49.99)
Save:
$40.00
126 Review
Add To Cart
-
Replacement Refrigerator Water Filter For:
EDR4RXD3
2-Pack ($34.99)
Save:
$35.00
110 Review
Add To Cart
Savor fresh and sweet beverages or cups of coffee filtered by edr4rxd3 in your kenmore refrigerator. Certified by IAPMO and NSF/ANSI standard 42, activated by first-class carbon, Clatterans edr4rxd3 will capture the particulates, dirt, sand, rust and other sediments for performing clearer, cleaner drinking water and ice cubes to your family and friends. With a durable and long-lasting six-month lifespan, feel assured to get quick flow rate and healthy drinking water in the following days. Invite your fellows to your house now to open a fabulous gather now to enjoy the blinking drinks and dishes owing to the flowing water from your kenmore fridge.
Fits The Following Series
72012 Series
72019 Series
78572 Series
78573 Series
78574 Series
1. Locate the filter cartridge holder in the back upper right hand corner of the refrigerator. To open the cartridge cover, where indicated, push in and the cover will drop down
2. Remove the old filter by slowly rotating it to the left. A small amount of water may drip down
3. Remove the red protective plug from the end of the new cartridg
4. Position the cartridge inside the cartridge holder. Slowly rotate the cartridge to the right until it stops.When the cartridge is properly installed, you will feel it “click” as it locks into place. The blade on the end of the cartridge should be positioned vertically. Do not overtighten
5. Close the cartridge cover.
6. Run water from the dispenser for 5 minutes (approximately 3 gallons) to clear the system and prevent air from entering the system
7. Locate the included Water Filter Replacement Calendar. Place the dark circle over the month that you installed your new filter. The light circle will indicate your tentative next replacement month. (This cycle can vary with water conditions and frequency of use).
Top customer reviews
-
By Robin On 2018-09-03 00:53:07
It fits my Maytag refrigerator perfectly. Make sure to read the directions and run water through the filter then discard the water. You can tell the difference.
-
By Katie On 2018-07-22 10:13:42
This UKF8001 filter produces nice clean crisp water. I've had it for a few weeks now and we drink a lot of water in my house and have gotten plenty of use out of it. Very happy with the purchase.
-
By Alejandro On 2018-07-17 03:54:16
I didn't realize how badly I needed to replace my filter. Thank goodness I ordered this. I won't wait so long next time. It went in super easy too.
-
By Brenda On 2018-07-11 02:26:05
So glad I found a water filter that will work on my Whirlpool fridge. I wasn't able to reorder. This filter 4 works great and this was a repeat purchase.
-
By Raymond On 2018-07-06 11:53:06
This filter is much better than the old one. We have very hard water and I noticed as soon as we replaced it how much more it filtered out. With the old filter, you could still see some of the sediment floating in the water even after it was filtered. With this new filter 4 it must have removed more.
-
By Leona On 2018-06-23 04:32:42
It is the one that I recommend for all of you who needs whirlpool filter and there have not been any problems. It is a bit more expensive but worth it. It fits well and easy to install.
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
Live Customer Support
Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.