Maytag MFT2776DEM
Fits The Following Models
Maytag Refrigerator Models
-
MFT2574DEE
-
MFT2776DEM
-
MFT2574DEH
-
MFT2574DEM
-
MFT2776DEE
-
MFT2776DEH
1.Locate the accessory packet in the refrigerator and remove the water filter.
2.Take the water filter out of its packaging and remove the cover from the 0-rings. Be sure the 0-rings are still in place after the cover is removed.
NOTE: There may be some water in the filter. Some spilling may occur. Use atowel to wipe up any spills.
3.Align the arrow on the water filter label with the cutout notch in the filter housing and insert the filter into the housing.
4.Turn the filter clockwise until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate. Water will not flow from the dispenser.
5.While the compartment door is still open, lift the filter up into the compartment. Then, close the filter compartment door completely.
6.Run water from the dispenser for 5 minutes at .5 gpm(about 2.5 gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours.
7.Reset the "replace filter" light, if needed, by holding the reset button for three seconds.
Top customer reviews
-
By Melba On 2019-04-18 09:12:00
Good product and service.
-
By Arne Francis On 2019-03-08 05:58:10
We received the water filter for our new Kitchen Aid appliance which was experiencing poor water flow from the dispenser and poor ice making capability. We installed the Clatterans filter and flushed 2 gallons of water through it as per the instructions and the problem was resolved. Great order processing also as the filters were delivered as promised. Thanks, I will be a return customer.
-
By Elvira On 2018-12-31 10:39:08
I found exactly what I was looking for with little effort. I had never had to buy one before so wasn't sure. They are expensive but got to have it.
-
By Patricia On 2018-12-29 08:20:17
It does clean the water. Nice white color. Lasts 6 months. Does not bestow superpowers on either the fridge or the drinker, but makes your clean and bland tasting, which is good, right? Fits Kitchenaid.
-
By Keller On 2018-12-29 05:38:09
Filters our water just fine. Product meets expectations. Our water is from a well, so you never know what's going to be in it--yet with this Whirlpool filter our water stays fresh and clean! Would buy again.
-
By Jeanette On 2018-12-27 04:28:49
Appears to work well. Fit my Maytag refrigerator perfectly and the water comes through it fine -- not noisy and the stream is strong and steady! Yes -- I'd buy it again!
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
Live Customer Support
Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.