Kenmore 70319
Fits The Following Models
Kenmore Refrigerator Models
-
70312
-
70313
-
70319
-
70342
-
70343
-
70349
-
70412
-
70413
-
70419
-
70423
-
70443
-
25370312211
-
25370312212
-
25370312213
-
25370343415
-
25370343416
-
25370343417
-
25370343418
-
25370343419
-
25370349210
-
25370349410
-
25370349411
-
25370349412
-
25370349413
-
25370349414
-
25370349415
-
25370349416
-
25370312214
-
25370313210
-
25370313211
-
25370313212
-
25370313213
-
25370313214
-
25370319211
-
25370319212
-
25370319213
-
25370319214
-
25370342210
-
25370342410
-
25370342411
-
25370342412
-
25370349417
-
25370349418
-
25370349419
-
25370412410
-
25370412411
-
25370412413
-
25370413410
-
25370413411
-
25370419410
-
25370419411
-
25370423410
-
25370423411
-
25370423419
-
25370342413
-
25370342414
-
25370342415
-
25370342416
-
25370342417
-
25370342418
-
25370342419
-
25370343210
-
25370343410
-
25370343411
-
25370343412
-
25370343413
-
25370343414
-
25370443210
-
25370443410
-
25370443411
-
25370443412
-
25370443413
-
25370443419
-
2537034241D
-
2537034341D
-
2537034941D
-
2537041241B
-
2537041341B
-
2537041941B
-
2537042341A
1.Turn Off the ice maker and remove the filter by pushing on the end/face of the filter.
2.Slide the old water filter cartridge straight out of the housing and discard it.
3.Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
4.Turn the filter clockwise until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate.
Water will not flow from the dispenser.
5.Push firmly until the cartridge snaps into place
(you should hear a click as the cartridge engages the snap-in connector).
6.Run water from the dispenser for 5 minutes at.5 gpm (about 2½ gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours
7.Reset the “replace filter" light, if needed, by holding the reset button for three seconds.
Top customer reviews
-
By Muriel On 2018-03-19 03:38:05
I used to buy the original GE filter and now I found this generic filter replacement is much cheaper than the GE original. It works and fits perfectly. I'm so happy to find it.
-
By Willis On 2018-03-17 11:50:11
The water coming through this filter tastes just as clean and fresh as through the original GE filter, at a fraction of the cost. Only the package has a little flaw.
-
By Alyssa On 2018-03-16 08:07:06
I weighed the decision whether to go with these filters or purchase directly from GE. The lower cost of these was a factor in choosing this product. After receiving the product and installing, I have to say it was easy and the quality of the water is good. I would recommend this GE Smart Water WMF and seller.
-
By Hope On 2018-03-15 07:55:01
Great way to replace my water filters and the price for three was cheaper than buying one locally. Thank you. Although the shipping is not fast enough.
-
By Celia On 2018-03-14 02:09:17
Great, works Just as good as the GE WMF Filters at half the cost. Have used these for a couple of months and keep coming back. Excellent quality filter.
-
By Jennie On 2018-03-13 06:02:11
These GE compatible water filters are a fraction of the cost of regular filters previously purchased through GE and it fits perfectly.
How often should you replace your water filter?
- On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
How do I turn off my filter light to reset?
- If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
Do the gaskets (o-rings) on the filters need to be lubricated?
- Most water filters come with pre-lubricated O-rings
- If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
- You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
Live Customer Support
Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.